ADVANTAGES OVER COMPETITION

Coffee Quality:

• Gravity dispense tube allows for consistent water volume per brew.
• Elimination of periodic maintenance of corroded brew solenoids. Gravity dispense tube locates above the water line when not in use thereby resisting lime build-up.
• Electronic controls are more reliable and accurate than mechanical.
• Electronic thermostats, timers, and mercury relays provide the most reliable consistency - - brew after brew.
• Water is at "Brew" temperature during 100% of the brew
• Insulated LUXUS® Thermal Dispensers maintain serving temperature without warmers for extended periods

Safety:

• Brew basket is locked down during the brew cycle with a safety latch.

• No need to turn down the thermostat during initial fill cycle, because the brewer will not begin to heat until the tank is full of water.
• Thermostat provides +1 / -2 degrees of accuracy minimizing initial calibration.
• All FETCO®  brewers are tested and pre-set at the factory for temperature and water volume, expediting the installation process.

Serviceability:

• Commonality of parts provide for reduced spare parts inventories as well as truck and warehouse space.
• Ball valve drain provides the safest and most efficient way to drain the brewer on the market.
• Top mounted heating elements means faster changing of the elements, no need to drain the entire tank.
• Mercury relays needs less periodic replacement than open air contactors.

Brew Volume:

Full Batch - 1.5 gal. (5.7 liters)
Half Batch - 0.75 gal. (2.8 liters)

Average Brew Time:

Full Batch - 4-4.5 minutes
Half Batch - 2-2.25 minutes

Water Temperature: (factory setting)

205°F inside water tank
195°F ± 5° at spray head
 

Coffee Amount:

6-12 oz.
(Follow your coffee supplier's recommendations)

Bypass Range:

 0 to 33% of brew volume
 (factory set at 0% unless specified)

Water Requirements:

20-75 psig
1¼ gpm
cold or hot water
3/8" male flare fitting is provided